My HDDs which are attached to motherboard SATA show up when running Snapraid Smart commands without issue.

However the two HDDs I have attached to my Dell Perc H310 HBA in IT mode don’t report Smart results from Snapraid.

Smartctl only shows these two drives as SCSI devices when I do a “smartctl --scan” command.

But these drives that are attached via HBA don’t appear when running “Snapraid smart”

Does anyone know how to get Snapraid to see the drives when running Snapraid smart command?

I’ll be adding many more drives to my HBA soon, and would like to figure out this issue.

​

  • silasmoeckel@alien.topBEnglish
    1·
    1 year ago

    All it’s doing is a smartcl -a to each device. It works fine on my 3 HBA’s all SAS2008

    You can change the command it uses for smartctl via the config, -d sat may be needed.