Nice! I am using the same pen!

Sorry for the late answer. It’s this one:

https://amzn.eu/d/04M6Ih6n

I literally just had my finger over the order button for one of these Nokia 3310 Remakes, but I didn’t order

Maybe that helps:

https://docs.google.com/spreadsheets/u/0/d/1-moGrSlTVI7w-vad6vdJm2D3wruPa_xP_inucLQnpNI/htmlview#

Of course! Here is the PSU Foot:

https://www.thingiverse.com/thing:5793825

For my PSU it was a bit too thick, but I managed to mount it anyway.

Here is the Cover I made myself:

https://www.printables.com/de/model/601820-voxelab-aquila-psu-cover-for-92mm-fans

And fan cover is just some basic 92mm cover, there are plenty out there.

The Mainboard housing also is my own creation, but I failed horribly with the screw holes for the board, so I strapped it in there using cable ties for now. I have to make another version some day that is good enough to be uploaded.

Oh yes, me too :D I got one for the waste of each material I am printing. PLA, PETG and TPU

Nebenkostenabrechnung… aktuell auch sehr beliebt

I have all of them. Am I more 30 than others people?

I already tried that, didn’t work. I increased the runout distance and sent some M412 commands to configure everything before a test print. It then seemed to work, but when I cut the Filament to simulate a runout it didn’t work. Sending the sensor back if I can’t get it to run this weekend

Did you use TPU for the prints? If you used PLA, that really was a bad idea. With TPU my drop tests (not on purpose) were successful and the phone without damage everytime (so far)

My iPhone 13 Mini case is now ready to be downloaded:

https://www.printables.com/de/model/542007-iphone-13-mini-case-with-lanyard-holes

Really nice job! Looks great