Apart from blow up printers, the one scariest thing for me about a slicer is losing settings. You spend hours getting your printer dialed in, specific profiles per material and then…

You update your slicer software and it all goes away. I have now learned Cura does this. And does this a lot. Forum posts abound about it. Friends recommend I switch to Prusa because it happened to them. Unfortunately too late for me to write down my old settings, and they’re apparently not in the ~/.config/cura folder anymore. Nice.

  • dumbcrumb@lemmy.worldEnglish
    101·
    9 months ago

    Yea I remember switching to prusa slicer because of this and I also seem to get nicer prints aside from seams not being great but I alsp haven’t put much effort into trying to fix that. Never lost my settings on prusa.

    • fmstrat@lemmy.nowsci.comOPEnglish
      31·
      9 months ago

      Yea, planning to give it a try. I just found the settings in .local/share/cura so that’s at least a good thing, but what a headache.