Why are 3D printers still stuck on stepper motors? Why haven’t we transitioned to servo motors with encoder feedback for positioning?
Is it just too cost prohibitive for the consumer-level? We would be able to print a lot faster and more accurately if we had position feedback on the axes. Instead we just rely blindly on the stepper not skipping any steps when we tell it to move, hoping for the best.
I mean, 3-axis robots move at 2000m/s with 0.01mm accuracy with payloads weighing considerably more than 3D printer toolheads, using servos.
Yes. 2000m/s and 0.01mm accuracy unfortunately means nothing about acceleration and control.
Knowing your system, you can achieve that with motors that can only accelerate at 0.01m/s² and that cannot break.
The 2000m/s and 0.01mm accuracy say nothing about the capability of the hardware in the case of multiple sudden direction changes.
That’s like saying “this car has a top speed of 200mph, and can reach any GPS coordinates precisely, so of course it can zigzag from side to side using 160° turns in a one way street at high speeds.”
The bottleneck is the extrusion and the cooling of the extrusion. Not the transport system.
2 km/s? That’s almost Mach 6.
Yea that’s why you have to wear hearing protection in factories.
Yeah that was a typo, obviously that was supposed to say mm/s
What’s the cost difference between the two?