Same… it’s hard to justify getting the most expensive tools when I only use them once every 3-6 months. If other people want to spend their money keeping up with tool brands that’s a competition I’ll gladly lose. Got better things to spend my money on.
This was me, with my few random ryobi tools, until I needed something new and saw one of those big combos of several tools from DeWalt was half price. So I lucked out being in the right place at the right time and got the best of both worlds.
Fortunately I already have like 4 DeWalt batteries. Somebody gave me a couple as a gift some time after I got the tool set. We definitely still have a Ryobi battery or two around as well!
They are fine for anything which doesn’t require precision. I have a Ryobi bench sander and it’s a complete waste of time. Same with the chop saw I unused to have. It was basically impossible to get flush miters from it no matter how much you adjusted it - the tolerances were just too low. My DeWalt table saw and Chop saw don’t have the same issues. They cut sub-mm precision on day one and still do years later. The table saw in particular is technically a worksite saw, buy you can use it to build cabinets with the right blade.
Same… it’s hard to justify getting the most expensive tools when I only use them once every 3-6 months. If other people want to spend their money keeping up with tool brands that’s a competition I’ll gladly lose. Got better things to spend my money on.
This was me, with my few random ryobi tools, until I needed something new and saw one of those big combos of several tools from DeWalt was half price. So I lucked out being in the right place at the right time and got the best of both worlds.
In case you are not aware you can get Adapters for one battery system to another. They make Ryobi to DeWalt and then back again.
Obviously don’t use them with the chargers.
Good to know, thanks!
Fortunately I already have like 4 DeWalt batteries. Somebody gave me a couple as a gift some time after I got the tool set. We definitely still have a Ryobi battery or two around as well!
They are fine for anything which doesn’t require precision. I have a Ryobi bench sander and it’s a complete waste of time. Same with the chop saw I unused to have. It was basically impossible to get flush miters from it no matter how much you adjusted it - the tolerances were just too low. My DeWalt table saw and Chop saw don’t have the same issues. They cut sub-mm precision on day one and still do years later. The table saw in particular is technically a worksite saw, buy you can use it to build cabinets with the right blade.