This is the only place in the whole print where this happens.
You got more pics and details please?
Well, this part is missing filament, looks like the nozzle wasn’t pressurized enough, but I don’t know why. The supports (now removed) on that side looked the same.
Here’s a picture with more of the model:
Here it’s as close-up as my camera can get while maintaining some detail:
And here’s what the other side looks like and what this one should look like as well:
This looks similar to a problem I was having. Turned out that my extruder wasn’t calibrated properly and it was pushing far less material then expected. Try running an extrusion test like described in https://ellis3dp.com/Print-Tuning-Guide/articles/extruder_calibration.html
I have this kind of issue with shitty white filament. Changing the filament with better quality ones solves the issue.
For this roll of filament, it looks like a retractation setting problem. When the head “jumps” across the hole, the printer retracts the filament to release the pressure. If the retractation setting it too high, it will starts the new slice with a lag in the pressure, leading to underextrusion.
You may try to calibrate your retractation setting. The value should be lower. You may get other artefacts (filament residue in the hole) but it’s easy to clean.
You can make a “retractation tower” to get the best value.
Will try, but the filament is great (Prusament PLA) and the retraction settings are the default in PrusaSlicer for my Prusa printer (MINI) and the aforementioned Prusa PLA.
But thanks, will try playing with retraction settings the next time.
Check that the feeding gear on the extruder is properly engaged on the filament.
I had this issue and it turned out the pivot point on the extruder had gotten sticky, so the spring wasn’t compressing the gear onto filament enough to reliably grab it.
I have this with relatively old black filament I own. It’s okay for larger areas, but smaller ones will underextrude. Is the filament old, by chance?
It’s called “Unretract underextrusion”. It can be caused by problems in the hot end, or a problem with your settings (not extruding enough overall, retracting too much and molten material making its way into the cold-zone of the printhead), and other such things.
