Would this be a good idea? The bottom surface of the printed things would be way more flat. Anyone tested this? Any reason why i shouldnt test it?

  • JohnDClay@sh.itjust.works
    link
    fedilink
    English
    arrow-up
    3
    ·
    1 year ago

    The surface is textured so that the parts stick better. If you want a smooth surface, it should be fine to turn it upside down. But you will be a little more likely to have prints come off the bed.

  • itdongo@lemmy.sdf.org
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    I have printed on the smooth side. At first the prints stuck well. Then the border started releasing. I tried brim but that did not help. Tried a glue stick which worked but it took away from the smooth finish. Tried a very light coating of hairspray and it worked well.